You should never use bleach in a misguided attempt to sterilize a water bath because it will corrode the stainless steel interior.
Laboratory water bath maintenance.
When the pan is removed for cleaning ensure the unit is unplugged.
This is especially important if the water is stationary or has been boiled.
How scientists use a bath also matters.
Use only a damp cloth with mild detergents avoiding any corrosive cleaning agents.
5 3 wash the lid properly with purified water.
Wipe any debris off of the seal and avoid spilling water into the unit to avoid damage to electrical components.
Use only distilled water float the sample so the lids stay dry and keep the bath covered as much as possible.
5 1 switch off the mains.
Cranson adds place your bath away from high traffic doorways and out of direct sunlight.
Regularly adding fresh water will replenish the oxygen which helps maintain the protective chromium oxide layer on the stainless steel.
5 1 ensure that the platform is dry.
5 2 ensure the water level in water bath.
5 2 connect the power supply.
Some top tips include the following.
Clean the bath with soapy water and a cloth.
5 4 remove the water from the water bath and wash the water bath with purified water and mop with a clean dry cotton cloth.
Our microprocessor controlled thermo scientific water baths provide superior temperature uniformity for your specific applications and offer unique features such as a seamless stainless steel interior chamber and epoxy coated exterior which make them resistant to corrosion and chemical damage.
It is important to refill the bath with the right kind of water.
Clean the empty bath with soapy water and a cloth.
Since almost all laboratory water bath has a digital interface to allow users to set a required temperature usually an indicator light turns on to indicate that the water bath is working.
Maintenance for water filled baths it is recommended that the bath is drained cleaned and re filled on a weekly basis to avoid build up of salts and contamination.
Once the correct temperature is reached the laboratory water bath turns on and off to maintain a constant temperature.
Regularly adding fresh water will replenish the oxygen which helps maintain the protective chromium oxide layer on the stainless steel.
Afterwards thoroughly rinse the bath with water to make sure no soap is left behind.
5 2 remove the lid from the water bath.
Maintenance for water filled baths it is recommended that the bath is drained cleaned and re filled on a weekly basis to avoid build up of salts and contamination.
5 4 switch on the main power supply and instrument mains.
It should be sufficient to pour the heating element.
